oil injection block off instruction

[Wi§eCo-Bla§teR]

instruction

-Drain oil by removing drain plug on bottom of motor

-remove oil tank ¦ hoses to oil pump

-remove right side engine cover (small cover first) remove oil pump screws and take off oil pump and remove oil line from case.

-install 1 rubber stopper in the main hole from which the oil line was removed.

-now remove clutch cover(the big cover right side) and remove the e-clip and the pin from the oil pump shaft and slide the shaft out of the clutch cover.

-install the oil block off plate and gasket in place of the oil pump and tighten screws.

-clean off all gasket surface and install the clutch cover gasket and clutch cover.

-install screws on clutch cover case and install small cover(oil pump cover).

-add oil to transmition

-now remove small oil line from carb (the one that went to the oil pump) and installthe other vacum plug on fitting where the oil line used to be.this will keep your machine from sucking in air and dirt into the motor.

-DONT FORGET TO MIX YOUR OILWITH THE GAS ,yuou can use your injection oil to mix at 32:1
but i suggest Amsoil 100:1 all the way ...

Thanks

[Steve]

thanks alot

[Wi§eCo-Bla§teR]

no problem!

[Steve]

man iam a dumb ass do you think i can to all that

[Wi§eCo-Bla§teR]

yes you can do it

[Steve]

awsome

[highflyintrx90]

no he could break it

[Wi§eCo-Bla§teR]

lol

[Steve]

KX65rider said:

no he could break it

lol thanks alot

[Quadguy]

lol. ;D

[|~RaYne~|]

you guys are fricking crazy....lol

[blaster200boy]

why do you want to remove it??

[|~RaYne~|]

you dont have to but after a little wile your motor will blow up cuz the injecter will stop and you will put stair gas to your motor
~~Rayne~~

[Quadguy]

Its also better having your own ratio insted of an injector to do it.

[|~RaYne~|]

you have to watch it when the injecter is doing it cuz it can mess up and mix it like 50:1,20:1,ect. you cant tell what is mix as you will be more pracise mixing it your self