stripped head stud

new

« Prev
1
Next »

ampegamp
Private

Posts: 135

stripped head stud Sept 23, 2004 19:39:03 GMT -5

Quote

Post by ampegamp on Sept 23, 2004 19:39:03 GMT -5

I recently took the head off a 1996 blaster and found that one of the studs was spinning in the cylinder. It did come out but some of the threads came with it. I ran a tap through the hole and cleaned the threads up, but the stud will not tighten down in the cylinder. What should I do? Helicoil?

2004 - Orange plastics, HWD pd3 190psi, prop head, ported reed cage, taper bored/polished cr125 carb, HWD intake, bills p/s, boyeson reeds, reed spacer, k&n with outerware, -8oz flywheel, holeshot tires, billet wheel spacers, +3 swingarm

blaster89 Private Posts: 236	stripped head stud Oct 4, 2004 15:13:42 GMT -5 Quote Select Post Deselect Post Link to Post Member Give Gift Back to Top Post by blaster89 on Oct 4, 2004 15:13:42 GMT -5 screw a nut all the way down to the head and keep titaning it will screww the head stud in then back it off and see if there tight
	sponsers www.snydermotorsports.net, my family,www.freewebs.com/blasterboi89

stripped head stud

Post by ampegamp on Sept 23, 2004 19:39:03 GMT -5

Post by blaster89 on Oct 4, 2004 15:13:42 GMT -5