Post by blaster99 on Sept 26, 2004 18:58:09 GMT -5
1. Pick your spot on the gate. If its a tar start sweep it first.
2. On the gate put it in the starting gear,1st or 2nd gear.
3. Sit as far forward as possable so you can realease the clutch hard.
4. Find the spot on the clutch were the quad starts to move. then pull it back in very little like a half milomeater.
5. When you see the pins underneath the gate start to move just a little dump the clutch, when dumping clutch push all your weight on the gas tank.
6. Riding now sift fast and take the hole shot
2. On the gate put it in the starting gear,1st or 2nd gear.
3. Sit as far forward as possable so you can realease the clutch hard.
4. Find the spot on the clutch were the quad starts to move. then pull it back in very little like a half milomeater.
5. When you see the pins underneath the gate start to move just a little dump the clutch, when dumping clutch push all your weight on the gas tank.
6. Riding now sift fast and take the hole shot
