|
|
Post by blasta13 on Dec 2, 2004 17:41:00 GMT -5
hi. i was wondering what size sprokets i should get for more acceleration and bottom end. i will have 18x10x8 rears and 19x6x10 fronts.
|
|
|
|
Post by kheft on Dec 3, 2004 18:30:31 GMT -5
stock gearing...anything with thoes 18"s you gear it any lower and you wont be able to keep the front end down.
|
|
|
|
Post by blasta13 on Dec 3, 2004 18:37:26 GMT -5
thanks
|
|
bradley300
Private
gncc sport class #812
Posts: 152
|
Post by bradley300 on Dec 4, 2004 0:39:50 GMT -5
he;s right but for everyone else, gearing breaks down like this
acceleration and less top speed= go smaller on the front sprocket and/or bigger on the rear
slower acceleration and higher top speed= go bigger on the front sprocket and/or smaller on the rear.
remeber 3 teeth in the back is the same as one in the front. for instance going up 1 toorh in the front will get the same result as going down 3 in the back. (its actually 1 in the front = two and a half teeth in the back, but obviosly you can get half tooth sprockets)
|
|
|
|
Post by blasta13 on Dec 4, 2004 11:28:36 GMT -5
im probably goin 1 smaller on the front and 1 bigger in the back.
|
|
|
|
Post by blaster99 on Dec 7, 2004 16:15:55 GMT -5
that will give u more low end
|
|
bradley300
Private
gncc sport class #812
Posts: 152
|
Post by bradley300 on Dec 8, 2004 4:31:17 GMT -5
sure would, i would think you would want back closer to stock gearing. for stock gearing with 20 inch tires, go to a 14 front, for bone stock gearing (22 inch tire) got w/ a 14 front and i minus 2 or three rear
|
|
