|
|
Post by BlackBlaster on Aug 28, 2004 13:16:03 GMT -5
i just got my new bars and theyre way too wide...what should i cut them with?
|
|
Adam
Private
This Blaster Will Soon Be Running On 4 Cylinders...
Posts: 279
|
Post by Adam on Aug 28, 2004 13:58:36 GMT -5
the easiest thing i can think of would be an air compressor grinder, if u dont know what that is it is jus a round grinder that connects to an air compresser and it spins n u can cut fenders n metal n pretty much anything with it.
|
|
|
|
Post by Elka83 on Aug 28, 2004 19:56:55 GMT -5
i used a chop saw  but not everyone has a chop saw just lieing around.lol |
|
|
|
Post by Quadguy on Aug 29, 2004 23:50:13 GMT -5
How about a pipe saw?
|
|
|
|
Post by PoisontheWell on Oct 24, 2004 21:55:38 GMT -5
I would say one of the easiest and cleanest ways to do it is with a pipe cutter. If your bars are aluminum, the cutter should have no problem getting through the material.
If they are a harder material, such as steel, it might dull the cutting wheel a bit, but should still do the trick. That is by the far the best way to get a clean straight cut, though.
If that doesn't work, then next would be a hack saw, then after that start getting into the grinders and power equipment.
|
|
|
|
Post by blaster99 on Nov 11, 2004 7:10:34 GMT -5
ya basicly a cut off wheel/tool thing the one from the air compressor
|
|
|
|
Post by vroomblaster on Nov 28, 2004 20:54:05 GMT -5
hack saw...BIOCH!  |
|
|
|
Post by blasta13 on Dec 2, 2004 18:52:54 GMT -5
grinder
|
|
|
|
Post by ~°CT^BLħTER°~ on Dec 15, 2004 17:49:46 GMT -5
maybe try a saw zaw
|
|
|
|
Post by xBlaster152x on Dec 26, 2004 22:44:02 GMT -5
hack saw.thats wut i use and it works every time.
|
|
