|
|
Post by fmfblaster2 on May 17, 2003 17:28:59 GMT -5
i got a pro design teather kill switch. it has two wires, one it says to hook to a ground and the other one they say to hook to the positive coil wire. wheres that at??? the ground wire is purposly shorter than the other wire and im soo confused where to put the positive coil wire one? help!?
|
|
|
|
Post by Malisiak05 on May 18, 2003 22:09:45 GMT -5
Ok, first lift off your seat. If you look were your air idle screw is....right next to that you will see 1 wire that has a boot over it and is hooked up to the coil, all you have to do is get the tether kill switch wire to meet with that wire. Run the cord along your frame or somewhere. If you need to know anything else about it just post.
|
|
|
|
Post by kittsy8 on May 5, 2004 21:29:09 GMT -5
when i got mine i was confused too
i ended up hooking mine up to the stock kill switch wire
|
|
