|
|
Post by buckmasterflex96 on Jan 10, 2005 13:49:17 GMT -5
i need to know what to do to break in a new motor if anybody can help that would be great
|
|
|
|
Post by VitosBlaster on Jan 11, 2005 3:44:01 GMT -5
Just keep your quad low on the rpms. If I remember correctly its 20 hours before you can start riding high rpms. Dont quote me on tho. And make sure you change your transmission oil on time....it will have plenty of metal shavings in it.
|
|
|
|
Post by blaster99 on Jan 11, 2005 7:12:39 GMT -5
ya lol
|
|
|
|
Post by buckmasterflex96 on Jan 11, 2005 11:04:51 GMT -5
so i can ride but i just have to stay under like half throttle??? and when im doing this about how often should i change the case oil???
|
|
|
|
Post by joshwestmx5 on Jan 11, 2005 16:11:53 GMT -5
I was told to ride sloely until after youve whent through a tank of gas
|
|
|
|
Post by VitosBlaster on Jan 11, 2005 23:55:31 GMT -5
Yeah I remember that when I got my motor rebuilt. So let me clear this up.
Its 20 hours(no more than half throttle) that they recommend when you have a brand new Blaster motor.
Rebuilt motors you just need to burn through 1 full tank of gas before you can go full speed or high rpms.
And change your oil when you normally do.
|
|
bradley300
Private
gncc sport class #812
Posts: 152
|
Post by bradley300 on Jan 20, 2005 10:31:59 GMT -5
make sure you warm it up good, ride for about 20 minutes with lots of throttle change, dont hold the throttle anywhere for long, full throotle is alright. then start riding it like normal
|
|
|
|
Post by Jarrett#20 on Jan 20, 2005 18:53:44 GMT -5
Ya the dealer told me 20 hours on the new motor under half throttle. But they told me i could go full throttle just "Quick Shift" and don't top it out. That's what they told me.
|
|
bradley300
Private
gncc sport class #812
Posts: 152
|
Post by bradley300 on Jan 21, 2005 8:50:11 GMT -5
do a little reading up and dont listen to a dealer. i think it's macdizzy that has a full write up on his site talking about why its better the break in your motor riding it hard like you would normally do
|
|
|
|
Post by Blu02Blaster02 on Jan 21, 2005 11:04:28 GMT -5
run it threw the heat cycles. If you search on www.BlasterHQ.com you will find a thread that YFS101 made I think. Has everything step by step. |
|
|
|
Post by Jay87 on Jan 21, 2005 14:43:20 GMT -5
Just go and fart about on low rpms and do it fo about 1 full tank then let er rip
|
|
|
|
Post by Blu02Blaster02 on Jan 21, 2005 16:18:06 GMT -5
you gotta run it threw its heat cylcles.
|
|
|
|
Post by hnaoutlaw on Jan 21, 2005 19:54:01 GMT -5
keep the engine loaded!!!!....Dont just start it up to listen to it run,and keep the engine under a load,dont rip through the gears and you should have succsess....i.e. acceleration...deceleration
|
|
.jpg)
